Advertisement

Making a Houndstooth End Grain Cutting Board!!

Making a Houndstooth End Grain Cutting Board!! ---⏱️Timestamps⏱️---
0:00 Houndstooth Cutting Board Pattern
1:37 Milling Lumber
2:04 Making Horizonal Wooden Stripes
4:56 Making Cutting Board Pieces
6:30 Building a Cutting Board Jig
7:56 Gluing Up a Cutting Board
9:28 Flattening an End Grain Cutting Board
10:42 Best Finish for an End Grain Cutting Board

I’ve always wanted to make a houndstooth end grain cutting board. Houndstooth is a timeless pattern and I think it would be a unique look for a cutting board. In order to create the pieces, I had to figure out what goes into the pattern. I broke it apart and ultimately it comes down to three square pieces: a light colored wood square, a dark colored wood square, and a square with four stripes of light and dark wood. Knowing that, I made the stripes first because they are the hardest.

I made my cutting board from oak and walnut. Maple would have looked really cool too, but I have a ton of white oak scraps that I need to use up. I made strips of oak and walnut and glued them together. Then, I cut them at an angle on the table saw, which made the direction of the stripes run at a 45 degree angle.

I cut oak and walnut pieces to match the width and height of the striped pieces. I glued the cutting board up in three stages. The first was to glue alternating oak and striped pieces. I glued a second panel of alternating walnut and striped pieces. Then I cross cut those panels about 1.5” wide and turned them on their edge. I got the houndstooth look by mixing the two panel pieces. The walnut/striped pieces need to be turned 180 degrees when assembling the cutting board. I glued everything together and flattened it using my CNC.

I cut bevels on the bottom so it’s easy to pick up, and after a healthy dose of sanding I was ready to apply finish. I went with my favorite finish for end grain cutting boards, which is a two step process of salad bowl finish and oil/wax. I thin out the salad bowl finish so that it easily soaks into the board. I want the finish inside the wood, but I don’t puddle it on top. After the finish is dry, the top area which makes contact with knives gets an oil/wax finish.

This turned out really cool and it may be my favorite cutting board project.

Here’s a list of tools and materials that I used to make this project. As an Amazon Associate I earn from qualifying purchases.
•• Tools & Materials ••
My Amazon Store:
Dewalt planer:
Jet 8” Jointer:
Random Orbit Sander:
Jet Table Saw:
Diablo Ripping Saw Blade:
Forrest Woodworker II Saw Blade:
Titebond III Ultimate Wood Glue:
Microjig Grr-ripper:
Starrett 6” combination square:
Axiom CNC:
Bosch Jig Saw:
Pin Nailer:
Salad Bowl Finish:
Butcher Block Oil:
Bessey Pipe Clamp:
Jorgensen Clamps:

•• My Links ••
My Amazon Store:
Website:
Instagram:
Facebook:
Esty:

genealogist woodworker,diy woodworking,woodworking projects,workshop tools,do it yourself,houndstooth cutting board,end grain cutting board,end grain cutting board patterns,how to make an end grain cutting board,wood houndstooth pattern,make houndstooth out of wood,woodworking cutting board projects,cool cutting board ideas,how to build a cutting board,woodworking for beginners,flattening a cutting board,cutting board project tips,

Post a Comment

0 Comments